Product Description

A wall coating material consisting of hydraulic binders, hydrated lime, selected aggregates (with dimensions of 1.5 mm, 2 mm, 2.5 mm, 3 mm), hidrofug materials and other additives to improve workability and adhesion.



For each bag of 25 Kg ITC FAÇADE add 6.5-7 liters of clean water and mix by hand or with mechanical mixer until a homogeneous mass is reached and there are no grains. Mixing time should not exceed 3  minutes.

It is advised to use the same amount of water for each bag. After mixing with water the material should rest for 10 minutes before application. Mixed material must be used within 2 hours, and if necessary mixed occasionally.





Spread the material with a metal screed in a uniform layer. Application of the material can be made by dividing the façade surface in small areas, not letting the material dry.





Final finish is done by a plastic sponge with various strokes according to the desired design. For ease of use and not to let the material dry quickly it is advised to divide the total surface area into smaller parts. Repeat the same pattern of scraping strokes over the entire surface to achieve a uniform appearance.




Used for interior and exterior decoration of different premises, whether residential or commercial facilities. It is used on various traditional surfaces; it has better results if used on pre-mixed products such as ITC  50 mortar, ITC 125 finish, ITC 175. It is recommended to be used on the surface previously treated with ITC PLAN. It is the material that seals a thermo isolating Capot Systems. It should not be used on gypsum, polystyrol or previously painted surfaces.


  • The application surface should be free from dust and Oil, wax, grease waste must be removed by wiping or scraping.
  • For surfaces which tend to absorb water or are very smooth (even a normal surface) it is advisable to use a layer of ITC PLAN beforehand.
  • This way of application is used to extend the drying time, this in cases when the surface which the material will be applied on is not leveled It is used also to ensure a better adhesion of the façade to the surface and to create surface waterproofing.
  • It is advisable to use material from the same batch for any work to be Material should be applied only on dry mortar. Avoid application on the facade when there is strong wind or strong sunlight.
  • Avoid application during the coldest and most humid times of the Minimum application temperature is 50C.


The item is packed in 25 kg bags with a protective layer from humidity.


To be stored in a dry place not more than 12 months.


ITC GRAFIATO is subject to constant quality control from Italcol laboratory.  Raw materials are also strictly selected and controlled. Products are certified according to ISO 9001-2008 standard and EN 998-2010 standard.

 tuv-austria  ce